The Hip book
Home » Bones » Tibia and Fibula » Supracondylar Femoral Frx: Pertinent Anatomy

Supracondylar Femoral Frx: Pertinent Anatomy

- Discussion:
    - when viewed in cross section, shape of distal femur resembles trapezoid w/ medial side inclinded about 25 deg & lateral side about 10 deg;
           - both the seating chisel and the subsequent blade plate should be 1 cm to 2 cm short of medial cortex to prevent inadvertent penetration;
           - this is due to the trapezoidal shape of the femoral condyles, which are narrower anteriorly than posteriorly;
    - posterior diameter is longer than the anterior;
           - therefore a plate which appears to be just the right length on AP view will be too long & will penetrate cortex and
                  protrude deep to the MCL or become subcutaneous;
           - correct length is 15 to 20 mm less;
    - anterior surface slopes downwards to medial side and corresponds in inclination to the patellofemoral joint;
           - care must be taken therefore that any device inserted is parallel to this inclination or it will end up in patellofemoral joint;
    - when distal femur is seen on lateral view, it is seen that femoral condyles appear to have been added on posteriorly to the shaft;
           - therefore, target for plate insertion is in middle of anterior half of condyles

Notice: ob_end_flush(): failed to send buffer of zlib output compression (0) in /home/datatra1/ on line 5349